Getting started with the HVBAN A3
· Airless Sprayer
A first-spray guide for the HVBAN A3. Published figures are the manufacturer's; the regional configuration, kit and manual are being confirmed and this guide will be updated when they are. Always follow the approved manual for your machine.
Before the machine arrives
- Coating and tip. Read the coating maker's data sheet. It names a tip size and often a pressure range. The A3's published maximum tip is 0.023 in; stay at or under it.
- Power. Confirm the regional electrical version and plug with us before the first job. Do not run the machine on a long, thin extension cord.
- Masking and protection. Airless spraying produces fine mist. Mask everything you do not want painted, cover floors, and plan for a respirator, eye protection and gloves.
- A practice surface. A sheet of cardboard or scrap drywall for your first passes.
Unboxing and first setup
Check the gun, hose, tip and guard against the packing list. Fit the hose to the machine and the gun, hand tight then wrench snug. Fit the tip guard with the tip arrow pointing forward.
Priming and the first pass
- Place the suction tube in the coating and the drain tube in a waste pail. Set the valve to prime and run until coating flows steadily without air.
- Switch to spray, point the gun into the waste pail with the guard off, and build pressure until the flow is steady. Fit the tip and guard.
- On cardboard, hold the gun about 30 cm from the surface, square to it. Start moving before you pull the trigger and release before you stop. Overlap each pass by about half.
- Raise pressure only until the pattern has no heavy edges ("tails"). More pressure than that is wasted paint and more overspray.
During the job
- Keep the gun moving and the distance constant. Corners and edges first, then the field.
- If the pattern narrows or spits, release the trigger, rotate the reversible tip, pull the trigger into waste to clear it, rotate back.
- Keep the inlet strainer clean. Stir, do not shake, the coating.
- Never point the gun at anyone or put a hand or finger near the tip. A high-pressure spray can inject paint under the skin; that is a medical emergency.
Cleanup and storage
- Relieve pressure. Switch to prime, pull the trigger into the pail, and lock the gun.
- Flush with the cleaner the coating maker names (water for most latex). Run until clear through both the prime circuit and the gun.
- Clean the tip, guard, gun filter and inlet strainer separately.
- Leave the pump with the storage fluid the manual names. Store upright, hose coiled loosely, out of frost.
Frequently asked
Should I get the A3 or the LF19?
The LF19 is the compact home model (published 1.9 L/min, 0.019 in). The A3 steps up on flow, tip size and motor and suits repeated projects and rental work. If you spray a few times a year, the LF19; if your projects repeat or grow, the A3.
Should I get the A3 or the EP270?
The EP270 is a contractor model (published 2.7 L/min, 0.025 in). If spraying is your weekly paid work, start there. If it is renovations, rentals and your own home, the A3.
Which paints can it spray?
Start from the coating's recommended tip and compare it with the 0.023 in maximum. An approved coating guide for the regional model will be published before sale.
What is in the box?
Machine, gun, hose and tip; the exact items will be confirmed with the regional packing list.
Need a person?
Send your coating, surface and project size. We answer in English and Simplified Chinese.